Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-27-2003, 03:31 AM
|
#3 |
|
Registered Member
Join Date: May 2003
Location: Virginia (DC)
Posts: 232
|
regarding what you said hammer, they actually reccomend that you dont put it into cars with low mileage. reason being that it is so slippery that it does not allow enough friction for the pistons to score the piston walls (or something to that effect). this happened in a new car that a friend of my fathers had when he added slick 50 at his first oil change. he went through the first engine, had it replaced under warranty, then had the same thing happen again (the company didnt know he used the slick 50 the first time, and didnt know why the engine died) ... the second time he didnt get it covered because they found out he had used the slick 50. so i understand that low mileage is a bad idea, i was thinking over the 100k mark it may help though?
__________________
1997 Mustang GT "Pacific Green" Flowmasters Bassani X w/cats Steeda Triax K&N and Air Intake Silencer Removed More to come with money! My Ride |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What size weld wheel to get a 26x10 inch slick on an 84 hatch | ciara | Windsor Power | 3 | 09-23-2003 09:55 PM |
| slick? | Cody2552 | Windsor Power | 0 | 04-22-2003 01:07 PM |
| slick and wheel prices/combos | Super_Stang | Windsor Power | 1 | 08-15-2001 05:32 PM |
| What is widest slick I can run on 8" wheel? | 8850 | Windsor Power | 3 | 05-19-2001 10:29 AM |
| bfg drags, weld draglights, MT slick question?? | LX XLR8R | Windsor Power | 4 | 02-27-2001 11:45 PM |