Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-08-2004, 12:44 PM
|
#7 |
|
Registered Member
Join Date: Feb 1999
Location: brooklyn center,mn,USA
Posts: 169
|
heres a pretty good article from right here on the site:http://www.mustangworks.com/articles...n/351swap.html
i used my 5.0 fluidamper so i didn't need the 351w damper and spacer. You need a oil pan, intake manifold and distributor, and headers to do the swap. maybe a couple of other parts... Well, i advanced the cam 4 degrees after shutting the dyno run down early(at 7200rpm). I'm hoping that will lower my max hp rpm to 7500 (or lower). I'm really hoping to see 500 rwhp, but that's optimistic. I WILL see 450 rwhp unless something breaks(God forbid). I don't know that torque will increase much if any going from a 1 5/8 to 1 3/4 header, but it is possible. Im probably a month from the chassis dyno. That torque number is wrong: my best torque was 465 @ 5600 fyi
__________________
88LX notch, Speedpro EFI 358windsor 11.2 to 1 compression, 5 lug baer claws all around..g force t5 and 3.55 gears. rwhp soon to come. Oh yeah...92 octane NO detonation. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W Heads on a 87 302 Block | NitroNixon | Windsor Power | 5 | 05-08-2003 09:29 PM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| Where to find 351W SVO | GodStang | Windsor Power | 0 | 10-11-2002 02:04 PM |
| 351W in a Fox body | greydan | Windsor Power | 4 | 07-03-2002 02:33 PM |
| HP #'s from a built 351W versus FMS 351 versus stroker | stroker393 | Windsor Power | 0 | 03-09-2001 10:24 AM |