Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-23-2004, 10:01 AM
|
#2 |
|
Registered Member
Join Date: Jul 2000
Location: Norman, Oklahoma, USA
Posts: 597
|
Most likely 28 spline. The axles are going to be a funky length though if I remember right. The rear end should be a tad bit wider than a normal stang 8.8 so that should make the axles a bit longer. (in case you're thinking of replacing the axles with 31 spline or something, might not work)
__________________
Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The LSC rearend swap | Nitrous Al | Windsor Power | 3 | 11-18-2001 07:29 PM |
| The Ford Sterling 10.25" rearend | Nitrous Al | Built Ford Tough | 4 | 09-06-2001 08:59 PM |
| my rearend is whining more than your ex-wife | swtstang | Windsor Power | 15 | 05-17-2001 01:27 PM |
| REAREND IDN. | POSCIVIC408 | Classic Mustangs | 3 | 04-08-2001 11:46 AM |
| Rearend swap | H'YAMULE | Classic Mustangs | 0 | 02-19-2001 09:48 AM |