Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-22-2004, 10:43 PM
|
#2 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
Pop the hatch and reset the fuel pump inertia switch. On older cars, these switches tend to be tripped a lot easier, sometimes even by slamming the hatch too hard. You could have some residual pressure in the lines, but the pump may not be working.
If you turn the car to the "ON" position, can u hear the pump working?
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Buy a U.S 1994 V8 5L GT Mustang in Australia (Imported from Japan)? | fearby.com | Windsor Power | 8 | 09-10-2002 09:27 AM |
| Looking for a Mustang | HighHeat | Modular Madness | 7 | 08-20-2002 06:07 PM |
| New Mustang | Mustang[RIP] | Classic Mustangs | 2 | 10-17-2001 01:50 AM |
| Mustang Club of Central Iowa - Car Show, Swap Meet, Cruise & Autocross - June 2 and 3 | KB1991 | Ford Show & Go | 0 | 05-31-2001 02:04 PM |
| Mustang Club of Central Iowa Autocross - May 6 - Marshalltown Go-Kart Track | KB1991 | Ford Show & Go | 0 | 05-03-2001 12:33 PM |