Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-10-2001, 10:47 PM
|
#2 |
|
Registered Member
Join Date: Jan 2001
Location: compton, CA, USA
Posts: 63
|
A while back I read an article on a mag, on how to replace the springs. It stated that on the rear springs depending on which way they face on the botton, (the last circle) will affect the height. Make sure both face the same way either the front or rear of the car.
Also when I installed my springs I didn't seat them right on the front. The end of the coil was out of its seat. Hope this helps. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New 4cyl Springs or Lowering Springs? | raptor | Windsor Power | 17 | 02-25-2004 06:48 PM |
| stocks springs vs. lowering springs | GhettoPop | Windsor Power | 1 | 02-12-2004 07:08 PM |
| lowering springs | my9250GT | Windsor Power | 5 | 03-05-2003 01:18 AM |
| Lowering my '96 - Springs? | ncbflo | Modular Madness | 1 | 06-30-2001 09:27 AM |
| Lowering springs, which ones? help | 97FORD GEE TEE | Modular Madness | 10 | 10-04-2000 07:17 PM |