Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-21-2004, 01:14 PM
|
#3 |
|
Rebel Fleet Commander
Join Date: Oct 2001
Location: Huber Heights, OH
Posts: 1,003
|
Re: advice on an eaton m-90 on a 5.0
No one makes a kit anymore. BBK's used to be based of the M-90, but I am not sure what the Snout length was on it. I am pretty sure it was a lot shorter than the M-90's found on T-Birds and GTP's. You could try getting the Kenne Bell Pipework and use it. I have seen people do that with M-112's off of Cobras and Lightinings, but not sure about the M-90's
__________________
1993 Mustang GT, PTK w/ T-64 - My Cardomain Webpage 11.25@123.5 on only 8 psi. 10.84@121 on only 1 headgasket    "The Truth is, Your the Weak, and I am the Tyranny of Evil Men!" 
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eibach advice needed | mustardjohn | Small Ponies | 6 | 08-19-2012 08:12 PM |
| Advice on injectors...PKRWUD I'd like your advice on this one as well | silver_pilate | Windsor Power | 3 | 06-09-2003 08:59 AM |
| Eaton Posi, Good buy? | zepherman | Windsor Power | 0 | 02-14-2002 04:09 AM |
| Header advice | mustangLX92 | Windsor Power | 8 | 11-09-2001 02:43 AM |