MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Upper Control Arm Bushing
Register FAQ Members List Calendar

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 02-15-2005, 01:23 AM   #2
gmhatr
Registered Member
 
gmhatr's Avatar
 
Join Date: May 2004
Location: Mattoon IL.
Posts: 91
Default Re: Upper Control Arm Bushing
you can either take a chizel and hammer and beat them out or heat it up and it should slide right out. When I replaced mine i did it both ways nad heating the sleve up was the easiest way.
gmhatr is offline   Reply With Quote
 

« Previous Thread | Next Thread »


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Upper control arm bushing glxstang Windsor Power 0 09-10-2001 12:57 PM
Steeda heavy duty upper control arm Yan88gt Windsor Power 0 08-09-2001 06:35 PM
REAR UPPER AND LOWER CONTROL ARMS bcinyuz Windsor Power 1 05-08-2001 04:17 AM
south side lift bars & upper control arm questions BowTie Eater 5 Liter Windsor Power 3 01-28-2001 05:39 PM
Rear upper control arms red82gt Corner Carvers Delight 2 08-01-2000 11:10 AM


All times are GMT -5. The time now is 10:10 AM.

Archive - Top

SEARCH