Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-22-2005, 05:58 PM
|
#1 |
|
Registered Member
Join Date: Aug 1999
Location: Las Vegas, NV
Posts: 202
|
A slightly different TPS adjustment question...
I did the search and read all the posts but here's my situation.
After a new throttle body installation, my TPS is reading -3.88v. (I have black lead on black wire and red lead on green wire) My car is idling a little high at 800rpm but is idling smooth. I've adjusted the TPS as far as it would go. So... do I drill out the holes in an attempt to get +0.95v? It's seems like mine is pretty far off but runs just fine as far as I can tell. If I leave it, will it hurt my car? Thanks for any and all help. I have found the most useful information regarding this here over all the other sites... |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another tire question | 96Saleen | Modular Madness | 6 | 02-10-2004 05:27 PM |
| A stupid question I hate asking about exhaust sound | jwboner | Windsor Power | 4 | 08-05-2003 05:55 PM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| SSM Liftbars Vs. Lakewood Liftbars, And A Quick Clutch Adjustment Question. | BowTie Eater 5 Liter | Windsor Power | 2 | 04-30-2002 06:56 AM |
| Question on Clutch Adjustment? | 88GStangT | Windsor Power | 4 | 02-09-2001 11:25 AM |