Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2005, 05:07 PM
|
#2 |
|
Registered Member
Join Date: Jul 2000
Location: Rochester
Posts: 323
|
Re: Pulled Codes, Please Help
it sounds like you may just want to change the whole EGR Assembly. A new valve an d solenoid is only going to run you about $75. If not just pull off the valve and clean it with some carb spray.
__________________
95 GT convertable, ported+polished GT40 heads, port matched upper and lower Cobra intake manifold, Flowthech headers, Catco hi-flow h-pipe with 2 hi-flow cats, Mac true fit catback exhaust, 3.73 gears, underdrive pullies, Edelbrock 70mm throttle body, Mac cold air intake, FMS 24lb injectors, Granatelli 75mm mass air |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pulled the codes off my eec iv | 84gt347 | Windsor Power | 5 | 01-23-2004 05:25 PM |
| Pulled codes...what do they mean? | Hethj7 | Windsor Power | 8 | 06-12-2003 12:03 PM |
| Pulled intake and swapped fuel rails now getting codes. | Rebel79 | Windsor Power | 3 | 09-03-2002 12:13 AM |
| pulled codes and could use some advice | Conman | Windsor Power | 9 | 08-17-2002 06:41 PM |
| Pulled codes today... | bobtodd | Windsor Power | 24 | 08-08-2002 07:55 PM |