Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-20-2005, 07:17 AM
|
#26 |
|
N-V-ME
Join Date: May 2005
Location: SOUTHFIELD,MICHIGAN
Posts: 155
|
Re: Porting stock heads
these HEADS HAVE A SMALLER COMBUSTION CHAMBER (HIGHER COMPRESSION RATIO)THEY WOULD BE GOOD CANIDATES FOR A PORT JOB...............
__________________
88' LX MUSTANG: LINCOLN ROTORS , AIR SUSPENSION FRONT AND REAR, SUBFRAMES, ROLL CAGE, 92' BLOCK, MSD 6AL, ACCEL 8.8 WIRES, ACCEL COIL, EDELBROCK F4B INTAKE (PORTED),2 IN. 4 HOLE SPACERS, HOLLEY 600 CARB.,HOLLEY BLUE FUEL PUMP AN REGULATOR, E 303 (.498 IN. 220 DUR.) CAM, (.535 IN. OF LIFT W/ 1.72 SCORPIN ROLLER ROCKERS), PORTED E7'S, FLOWTECH 1 5/8 LONG TUBE HEADERS, 2 1/2 IN. H PIPE, 2 CHAMBER FLOWMASTERS WITH 3 IN.DUMPS, T-5, 3.73 GEARS, 5 LUG AEROSTAR AXELS, 245-45-17 96' COBRA WHEELS |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Porting Stock Heads? | Whoapony94 | Windsor Power | 6 | 04-09-2002 06:47 AM |
| SystemaxII intake and Box stock RPM heads | NewAge 5.0 | Windsor Power | 4 | 01-18-2002 12:52 AM |
| Anybody use the GT-40P headers on stock heads? | Scappoose | Windsor Power | 3 | 01-15-2002 06:38 PM |
| TFS or Yates Heads on stock block??? | Stang Runner | Windsor Power | 4 | 08-18-2001 02:19 PM |
| Best Heads For Stock Short Block | StreetStang37 | Windsor Power | 2 | 02-26-2001 11:10 AM |