Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-27-2005, 12:21 AM
|
#1 |
|
Registered Member
Join Date: Jun 2005
Posts: 3
|
Dash Replacement. Extra Wire
Up until the dash replacement the 82 Mustang 5.0 ran great. While I was exchanging the dash I noticed that a wire had come loose or just fallen off. and I am not sure where it goes and the car rolls but it will not start. It is a thick yellow wire with a small metal clip so I think that it may have fallen out of a harness. Any help would be greatly appreciated. Thanks.
Chris |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wire route for aftermarket amp in '95 | The Jester | Audio, Security, & Electronics | 3 | 04-17-2005 05:49 PM |
| HEGO orange wire grounds to manifold?? | Simi Stang | Windsor Power | 2 | 12-19-2003 08:13 AM |
| again, How to cure code 66 (maf below minimum voltage) ???? | HAITHAM | Windsor Power | 6 | 11-12-2001 09:10 AM |
| stator wire..where does it go? | 82 GT | Windsor Power | 9 | 07-04-2001 10:40 PM |
| Aftermarket gauges in 85 dash, wire breakdown inside | RUSTANG | Windsor Power | 2 | 02-12-2001 11:06 AM |