Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-16-2005, 12:04 PM
|
#1 |
|
Registered Member
Join Date: Feb 2001
Posts: 84
|
clutch not fully disengaging/engaging
got a weird one. had a new clutch disk, pressure plate and cable put in about a year ago. worked fine. now, recently, the clutch engages right close to the floor board and is hard to get into gear. Replaced the quadrant and still same problem. any ideas? What else is weird is that sometimes when you first start up in the morning, it shifts fine. Then later it becomes hard to get into gear. thanks.
__________________
1990 LX 5.0 Cobra Intake K&N filter ET 15.0 Yokohama ES 100. Cobra R 17's DynoMax SS's Pro 5.0 More to come |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| Bad clutch or T/O bearing? Pics | Rebel79 | Windsor Power | 3 | 05-26-2002 11:05 PM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |