Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-04-2005, 01:39 PM
|
#4 |
|
Registered Member
Join Date: Mar 2004
Location: Minnesota
Posts: 950
|
Re: 5 lugs
Hmmm, im not exactly sure on the combatibility of the 67 and 68 spindles... They will work, im just not sure if you have to swap the tie rods or not. I would imagine you would, because your going from 6cly to 8cly suspension. If going to disc, you should swap to a dual master cylinder. You will have to put in a porportioning valve inline with your rear brakes. If your pulling this off a junkyard car, i would grap the spindles/dics assembly, pitman arm, idler arm, center link, and rear end. Buy new tie rods. The dual master cylinder could also come out of the junk car.
__________________
Alex |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3 inch lugs for slicks?? | Simi Stang | Windsor Power | 4 | 04-07-2004 02:28 PM |
| Rotors? | Budiak | Classic Mustangs | 16 | 07-22-2002 08:40 AM |
| Rusted lugs and washers | Bad89stang | Windsor Power | 5 | 04-14-2002 12:04 PM |
| Change from 4 Lugs to 5 Lugs | 86PonyCar | Windsor Power | 3 | 02-28-2002 07:20 PM |
| How to convert from 4 lugs to 5? | KG88GT | Windsor Power | 4 | 10-30-2001 10:07 AM |