

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#2 |
Registered Member
Join Date: Sep 1998
Location: Oviedo, FL
Posts: 992
|
![]() All depends on your mechanical knowledge. Either of the two regulators aren't "Hard" if you are mechanical. But, if you aren't....they're hard.
Get a shop manual if you don't know. To get to the rear, 1/4 window: 1] Pop seat bottom out, from front of seat bottom 2] Take the rear seat back out, two screws holding at bottom near seat belts. 3] Remove window crank. 4] Remove door sill plate 5] Remove windlace 6] Remove 1/4 trim panel, couple screws, clips, etc. 7] Remove and replace regulator assy.
__________________
"Support our Troops" Dave 1968 Cougar 2004 Thunderbird 2007 F150 Harley-Davidson, SuperCrew 1986 LTD 1997 Ranger 1992 Honda Civic |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installing a WIndow Regulator | trndkll67 | Classic Mustangs | 2 | 05-26-2005 10:38 AM |
Driver Side Window Gets Stuck?? | Dayton_GT | Windsor Power | 2 | 05-20-2003 02:00 PM |
whats left of the right side of my truck | andy669 | Blue Oval Lounge | 11 | 01-15-2003 11:22 AM |
those pesky window regulators | nicolette | Classic Mustangs | 5 | 12-08-2001 03:41 AM |
SIDE MOLDING ON SIDE WINDOW | 89FHPLX | Windsor Power | 6 | 01-06-2001 02:05 PM |