Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-09-2007, 11:25 AM
|
#3 |
|
Registered Member
Join Date: Apr 2001
Location: Hampton, Virginia
Posts: 227
|
Re: Tremec 5 Speed Install Help
That helped out alot and me setup for just about everything but they did not talk about a pilot bearing or is that the same thing as the throwout bearing?
The transmisson I got is out of a 01' GT and the bellhousing does not remove like that which is starting to make leary of what I got. I want to put it on a 302 and thought that I could replace the bell housing to make it fit but when I pulled the bell housing off I saw all the gears behind it. The bell housing is held on by 12 bolts which bolt from the inside of the bell housing. Or will this bolt up to a 302 block? This is the tag on it: XR3R-7003-AB RES AB 1002 1381-011 038372
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse. 1966 Mustang still in progress |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 98 v6 how to install speed chip | cowboysdad | Power Adders | 0 | 09-12-2006 07:34 AM |
| Tremec tko install | 68302 | Classic Mustangs | 2 | 01-26-2003 03:00 PM |
| Tremec Install - Finally Made Appointment!!!!! | NO SLO PK | Windsor Power | 1 | 12-21-2001 04:34 PM |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| Tremec Install Question | Tony91LX | Windsor Power | 1 | 04-30-2001 04:32 PM |