94 cobra seat install!

[bmxmon]

Originally Posted by rwhite65

What kind of modifications are you having to do to the car to get those seats to fit in there?

Nothing too hard at all actually. (nothing to the car itself if you didnt want too)<-edit I lucked out and the rails are equal distance apart, old vs new. Here is a link to a write up I did: http://www.cmbracing.com:5599/late&#37;2...20install.html I still have yet to buy another manual frame rail to install the other one, plus I still need to lower the pedestals for a better ride height. (they sit just slightly too high for my tastes.) I was going to do that last weekend, then ran into my floor problem and decided to deal with that first. Not sure if I will be able to get around to it this weekend either, helping some friends move.
(added a pic of one of the seats with the headrest off)

Originally Posted by stanger66

Do you know how to fix the cowl because I know mine leaks because I found out the hard way. I took the car wash and I found all my leaks (front and rear windows, side windows-all,cowl,heating tubes,doors,trunk) and there is nothing like getting sprayed in the face by a high pressure spray and swimming in the floor boards and punching a drain hole in the trunk to drain it. I'm sure the gas station had problems with the vaccuum later I made it into a wet/dry vac sucking the water from the interior.hehehe

I've personally never done it, but I believe i will be in the future! Here is the good site I was talking about: http://www.mustangmonthly.com/howto/75438/ Sounds like you may have it worse than mine. (cant top my buick though) Air and water leaks are the worst part about classic cars.