Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-28-2001, 07:38 PM
|
#1 |
|
Registered Member
Join Date: Oct 2000
Location: Santa Lucia di Budoia, Italy
Posts: 217
|
Do I have to remove rack to install bushings?
I lowered the car a while ago but I didn't have time to put the offset bushings in. I just read an article that said I can just disconnect the 2 bolts and pull the rack forward to, uh, "facilitate entry".(heh, heh, he said..). Is this true? Can I do it without disconnecting the tie rods or the power steering lines?
------------------ 86 GT T-tops, AOD, B&M shift kit and hammer shifter, ROH wheels, K&N, Timing,MAC headers, 2.5 off road H, 2.5 American Thunder, 87 spindles, rear disc,SS lines, BBK 1.5, poly bushings, Steeda G-trac and subs, Strut bar. "DRIVE LIKE YOU STOLE IT!" |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems installing aluminum rack bushings | WhiteLX | Windsor Power | 0 | 02-01-2003 12:36 PM |
| Are bushings worth the trouble of having to install them? | Kamaro Killer | Corner Carvers Delight | 4 | 10-04-2002 04:08 PM |
| Steering rack install question... | Johnny Fort | Windsor Power | 5 | 06-13-2002 07:03 PM |
| What do offset rack bushings do? | blueneonman1 | Windsor Power | 4 | 11-14-2001 10:37 PM |
| Offset Rack Bushings? | fordgasm | Windsor Power | 1 | 01-09-2001 06:50 PM |