Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-17-2001, 05:59 PM
|
#3 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
egiap's 5.0 is correct, EGR gasses (exhaust) run up through the egr spacer and then into the intake, the coolant lines although being hot coolant is cooler than the exhaust gasses and supposedly cools it down, so i'd leave them there if i were you, unless you disconnect your EGR
------------------ 88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframes, 65mm TB, March ram air ,MSD coil, U/L control arms, 155lph f/p, Crane Adj.FPR, Nitto drag radials, best 1/4--> 13.76@101.4 on a 2.17 60ft |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| opinions on body mods | stanger9219 | Appearance & Detailing | 0 | 04-24-2004 11:10 PM |
| Need Throttle Body & Idle Conrol Valve Info | BigBobsL | Windsor Power | 2 | 02-10-2004 01:16 AM |
| body kit. | Poseidon | Modular Madness | 0 | 12-15-2002 09:11 AM |
| Any body in Orlando that does paint and body work?PEASE read | robertwigton | Windsor Power | 0 | 12-18-2001 02:15 AM |
| Oil leaking from thottle body | Mike_W | Windsor Power | 1 | 05-07-2001 12:11 PM |