Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-30-2001, 04:14 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: stockton, ca usa
Posts: 160
|
HELP!!!!!
Well I pulled my motor because I was having low oil pressure problems on my rebuilt block. SO I used the plastiguage to check my clearance today and all of the measured .003 execpt one that was .002 (the #3 cap). The chiltons says my clearce shoudl be
-.0004 to .0021 so there is too much clearance right? IS that my reason for low oil pressure? I had the crank miced and they said it was in factory specs, and I ordered stock sized bearings. What do I do next? Thanks, I am terrible with math I and this is my first time. Any help is appreciated. Thanks again!!! ------------------ |
|
|
|
|