Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-26-2000, 09:33 PM
|
#1 |
|
Registered Member
Join Date: Apr 1999
Location: Wilkes-Barre, PA 1968Mustang
Posts: 188
|
Rockers
My car had a tapping rocker and I pulled the valve cover and tightened them down so they werent moving. My engine is a 68 289 2v. My shop manual says that I should set each cylnder that I am adjusting to TDC but I didnt do that. I think the rockers are positive stop non adjusting on the 289 2v. Was just tightening the studs until they dont move all I had to do?
 I hope I didnt mess my engine up. It supprisingly runs a lot smoother now.------------------ 1968 coupe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dont use 1.7 rockers with stock heads? | Coupe5oh | Windsor Power | 10 | 11-28-2015 12:36 PM |
| Noise rockers Help?????? | 393Clevor | Windsor Power | 5 | 07-21-2003 06:44 AM |
| Rail Rockers on 289 Small Block Heads | sleeperstang | Classic Mustangs | 16 | 05-11-2003 11:34 PM |
| Roller Rockers, bad? | HiFlow5 0 | Windsor Power | 1 | 04-14-2002 01:35 PM |
| reg rockers or roller rockers?? | Chevysucks | Windsor Power | 1 | 12-05-2001 08:17 PM |