Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-25-2000, 05:09 PM
|
#5 |
|
Registered Member
Join Date: Mar 2000
Location: Carol Stream, IL USA
Posts: 2
|
I use the RPM set up in mine, first you dont need to pin or change the studs....I have had no problems with mine. If you are just looking for a performance "improvement" and something to cruise around in, go with the regular Edelbrock setup or something comparable, the RPM is more for racing and is not very happy turning low rpms around town.
------------------ Sit Down, Shut Up, and Hang On! Check Out my Home Page: http://badboy.stangnet.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cam selection | avbcon12 | Windsor Power | 42 | 10-10-2002 08:22 AM |
| cam selection | 85Coupe | Windsor Power | 3 | 07-19-2002 04:38 PM |
| Intake selection with a 383/408 stroker | Capri306 | Windsor Power | 12 | 05-03-2002 10:12 PM |
| Gear Ratio Selection | Green96GT | Modular Madness | 4 | 07-19-2001 11:40 AM |
| Gear selection | Grulla | Corner Carvers Delight | 1 | 03-13-2000 09:04 AM |