Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-07-2001, 02:08 AM
|
#2 |
|
Registered Member
Join Date: Mar 1999
Location: Tsawwassen BC Canada
Posts: 413
|
If the damge is near the bottom of the hole or at the bottom it shouldn't be much of a problem. How bad is it? Will a overbore clean it up? I have a 302 that had a similar problem. There was a bit of material at the bottom of one of the holes that was damaged but it was still good because it was not in the pistons travel. If you are still unsure then ask a engine builder.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Big Block swap | Sage427 | Modular Madness | 2 | 09-29-2004 08:49 PM |
| Need help deciding on an engine block!! | 93 Cobra needs input | Windsor Power | 6 | 10-23-2002 05:29 PM |
| 351 Marina block buildup? | Agent_4573 | Windsor Power | 3 | 06-30-2002 09:38 AM |
| What makes a Small block a Small block and a Big Block a big block? | gtsr515 | Windsor Power | 13 | 05-20-2002 10:25 PM |
| 86 block / E7 head question | 302man | Windsor Power | 5 | 11-13-2001 08:27 PM |