Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-29-2001, 05:24 PM
|
#4 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
i have a set of 10.5 inch slicks on some 10hole's, which are the same dimensions as your turbin wheels. The quad shock must be removed and you may wanna roll your fender lips in a little to be sure.
They are not too big for a 7" wheel for drag racing. But you dont wanna try to corner real hard cause you may unseat the bead on them. listen to someone who has done it before, not someone giving you his theory on it. go for it!
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Axle from 4 banger work? | 90LxDroptop | Windsor Power | 1 | 04-01-2002 08:54 PM |
| will a 91 mass air harness work in a 88 gt? | bryan88gt | Windsor Power | 5 | 03-24-2002 12:39 AM |
| Anyone get ragged on at work for driving a Ford? | Crazy Horse GT | Blue Oval Lounge | 25 | 03-10-2002 07:26 PM |
| will this work for forced induction? | mikos chris | Windsor Power | 0 | 01-14-2001 03:05 PM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |