Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
12-02-2001, 11:50 AM
|
#9 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
My old 88 gt ran a 13.4@105 2.0 60ft with stock heads, stock ported intake, under drive pullies, chip, stock gutted cats, dynomax mufflers, 3.55 gears, traction bars, sub frames, homemade ram air, k&n, stock headers, electric fan, no smog pump, and an aftermarket coil "the old one died". I did this on cheap bfg 225/60/15's. So I would think it is entirely possible to even get it into the 12's if done right.
__________________
James Cox RHC Member #44 nochevy@hotmail.com 1991 Mustang LX Dart iron eagle block, 4340 28oz 347 crank, 4340 h-beam rods, probe ultra light pistons canfield heads “race ported by Brent Frazier”, solid roller cam and lifters “custom grind”, kooks 1 7/8" race headers, and much more. Engine built by Brent Frazier. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| speed density systems | guitardawg | Windsor Power | 6 | 09-18-2003 03:26 PM |
| Speed Density Cobra? | UglyFast88 | Windsor Power | 6 | 12-10-2002 11:25 PM |
| 40 reasons FOR gun control | DAN-MAN | Blue Oval Lounge | 22 | 11-13-2002 05:19 PM |
| speed density question.. | bobtodd | Blue Oval Lounge | 2 | 04-15-2001 02:03 AM |
| Goodbye Speed Density, Hello Mass Air? | Sac68 | Windsor Power | 17 | 01-22-2001 10:39 PM |