Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-02-2001, 11:13 PM
|
#3 |
|
Registered Member
Join Date: Feb 1999
Location: Lake Zurich IL USA
Posts: 306
|
This truck is a SD truck and I have acess to the whole harness and computer. I looked into using the F150 computer and the mustang harness but the mustang harness is setup for Sequential fuel injection and the f150 is a batch fire. I know that the pins can be switched around, but I dont know if I can switch them around enough to make the f150 computer work on the mustang harness. Id rather use a 5.0 harness and computer because it would fit so much better in the engine bay. Im not quite sure how well the F150 harness will fit in the engine bay. I guess only time will tell at this point. THANKS
__________________
78 Fairmont, soon to be EFI 351 Twin Turbo 83GT, soon to be a 2.3 Turbo, thanks to a TBIRD 89 Ranger that is now painted RED, WHITE, and BLUE |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tuning a speed density system with mods | Fostang | Windsor Power | 6 | 07-10-2002 11:32 PM |
| 24lbs injectors and crower 15511 on speed density | Yan88gt | Windsor Power | 9 | 03-19-2002 10:16 AM |
| Speed density conversion | mustangLX92 | Windsor Power | 12 | 06-28-2001 01:49 PM |
| speed density question.. | bobtodd | Blue Oval Lounge | 2 | 04-15-2001 02:03 AM |
| Speed Density question (92 F150 5.0 E4OD) | 98GT4me | Small Ponies | 1 | 03-29-1999 08:07 AM |