MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Getting Weld Draglites, What offset do I need?
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 12-15-2001, 05:56 AM   #2
MikeWeber
Registered Member
 
Join Date: Aug 2001
Location: Louisville, KY, USA
Posts: 48
Default
They should fit fine with limited hammer work. It may rub a little on the inner fender well under full suspension travel, but then again it may not.
__________________
88 NMRA Pure Street coupe
95 GT-heads, cam, exhaust, intake, road-race suspension
97 Taurus SHO-K&N, ported meter
95 Escort GT-Pacesetter header & exhaust, Weapon R intake tube
MikeWeber is offline   Reply With Quote
 

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Threaded Mode Threaded Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Cleaning Weld Draglites. Help!!!!!!!!! eeh102582 Windsor Power 9 04-04-2004 03:37 AM
Weld draglites on a Turbo coupe rear QuantumMotorsports Windsor Power 0 09-07-2003 11:46 PM
Cleaning waterspot and road grim From Weld draglites eeh1025 Windsor Power 4 04-05-2003 08:26 AM
Poll: Weld Draglites or 5-spoke Cobra polished? TCMotorsports Windsor Power 3 08-25-2001 06:52 AM
What backspacing for Weld Draglites? 88GT5.013.02 Windsor Power 3 02-27-2001 04:52 PM


All times are GMT -5. The time now is 09:00 AM.

Archive - Top

SEARCH