Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-09-2001, 07:28 PM
|
#3 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
Will an e3o3 cam work on my stock 88gt (T-5) without using different rockers, pushrods, valve springs? Yes, but I would not recommend it without the springs because the valves will probably float at higher rpm's. It will hurt your low end torque a little and you will pick it back up high in the rmp's but not with out the springs.
Will I have to convert to mass air? No, but you might have a problem with the idle and drivability problems. Will I have a piston to valve clearance problem? No ------------------ James Cox nochevy@hotmail.com 1991 Mustang LX Best 1/8 time on motor 7.686 @90.20mph |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stock No More | Stroked408 | Windsor Power | 9 | 06-12-2002 08:19 PM |
| stock tach wont work | Beni | Windsor Power | 3 | 01-15-2001 08:03 AM |
| does gt40 intake work with sn95? | daz95gt | Windsor Power | 8 | 01-13-2001 08:20 AM |
| Need some professional advice - head work, valve springs, rockers, cam. pretty long. | AxemanZZ | Windsor Power | 15 | 01-11-2001 01:30 PM |