Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-21-2001, 07:04 PM
|
#5 |
|
Registered Member
Join Date: May 2000
Location: Everett, MA
Posts: 417
|
Phanton, what up neighbor! I rarely find other Massachusetts guys in here. I have a few tips for you before you start building this motor. I have had two different 5.0 Mustangs and I used both nitrous and superchargers on them. I never broke any of these engines, but I know if you want to make 500 hp or more, start with an A4, R302 or the new Sportsman 302 block. They're rated for over 650 hp, so it should be the last block you'll need to buy. After all, if you're going to spend big money on a crank, rods and pistons and put it in a "crack prone" stock block, you're wasting your money.
__________________
Nitrous Al |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power steering | RDRZ | Classic Mustangs | 0 | 03-02-2004 07:53 PM |
| power for 500 hp daily | Torinalth | Power Adders | 22 | 09-25-2003 11:54 PM |
| Power for the Power Amp | traderguy | Audio, Security, & Electronics | 2 | 07-13-2003 08:07 PM |
| Need Advice...whats holding me back..please help | dragstang86 | Windsor Power | 5 | 03-04-2003 08:32 PM |
| Electrical power, where to splice? | Chris_H | Windsor Power | 3 | 02-11-2001 08:29 PM |