MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 03-25-2001, 01:23 PM   #2
NOS_Notch
Registered Member
 
Join Date: Sep 2000
Location: Fresno,CA. USA
Posts: 384
Post

as you are looking down on the engine compartment....
lower left, very bottom is the smog pump..off the smog pump there is a steel tube that runs to the back of the heads.
there are some vac attatchments but if you looked at a boneyard car it would only take about 20 minutes to get all of it off.
make sure you get the steel tube from the y-pipe to the h-pipe. also you will need a hi-flow catalytic h-pipe( or weld the smog tube to the h-pipe) the y-pipe(which is probably gone) should now have thermactor plugs in it's place on the back side of the heads....i would say that's about it.



------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at http://www.burnouts.webprovider.com
NOS_Notch is offline   Reply With Quote
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Which is your favorite general auto parts store? Fox Body Blue Oval Lounge 28 12-07-2017 11:18 AM
Edel. non-smog to AFR smog legal heads? What do you guys think? Simi Stang Windsor Power 10 06-19-2003 11:14 PM
AFR 165's emissions legal vs. non emissions legal dragstang86 Windsor Power 1 12-11-2002 01:20 PM
PLEASE HELP!! Do I need the smog pump system to pass dyno emissions ?? Stang_ROTY Windsor Power 5 07-02-2001 01:09 AM
Missing Alot of parts - Need Help! Stang_ROTY Windsor Power 4 03-30-2001 11:59 PM


All times are GMT -5. The time now is 04:30 AM.


SEARCH