Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
12-22-2001, 10:19 AM
|
#1 |
|
dude5l
Join Date: May 2001
Location: Grande Prairie, Alberta, Canada
Posts: 603
|
I tried to find new bearings and seals for my Paxton and it turned some of the stuff was O.E.M. only. The only place I could get them was a paxton dealer, and they are not cheap! I ended up using some seals that were close on the I.D. and then using a speedy sleeve on the shaft to take up the clearance. Hasn't leaked so far. Anyways, my point is that some of the stuff may not be available from anywhere but Vortech, so unless you want to modify stuff get the parts direct, or send it there.
__________________
Good luck! Brad R. 1992 L.X. 5.0 coupe MODS: A few little bolt ons  New Best time ...11.60 @ 128 mph @ 2000+ ft altitude. Rice Haters Club member #39 Users rides #2542 |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vortech Supercharger | -viscid-01-GT- | Modular Madness | 5 | 05-09-2003 11:53 AM |
| 96 to 98 gt with a vortech blower ,, have a question 4 you ! | southernstang97 | Modular Madness | 8 | 07-31-2002 05:52 PM |
| cheap mafs at vortech | 7up | Windsor Power | 1 | 02-05-2002 03:14 PM |
| I am getting a vortech supercharger. Need help on preping my motor for it... | Dark_5.0 | Windsor Power | 7 | 09-21-2001 10:41 PM |
| 351 stroked to 408 + a Vortech S-trim@14# boost, good or bad? | bigwhitecobra | Windsor Power | 4 | 02-02-2001 11:16 AM |