help I have questions

dinomite · 03-28-2001, 08:29 AM

Ok, I'll work backwards cause you later q's are easier.
(H)Uhh, not looking at my car, but other than the connector that goes to the mass air sensor, it needs nothing.
(G)I'm pretty sure that its the same 8.8, and aught to work.
(E)In place of the stock, anything is. If your looking at new headers check out some long tubes, you need a new H but I've heard its worth it
(F)No idea, probably not, but as I said above, you could go w/ longtubes which require a new H. You could get the longtubes, an H with high flows and be set!
(3)Check your throttle position sensor (TPS), http://www.mustangperformancetech.ho...TPStuning.html
(2)Bent cross memeber eh? I dunno about this, but your best bet is probably to go grab one from a junk yard and replace yours.
(B)On the gears, get those installed by a good mechanic, it requires special tools, you can get the speedo gear from many mustang shops (texasmustang.com, mustangsunlimited.com)
(A)The stock axels are 28spline, I don't know what else you have to replace if you change them (diff?) but you may want to make a trip to the junk yard again.....You didn't ask about the front rotor/spindle I guess you have that under control?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Just got a 98, have some questions?	98GTNewbie	Modular Madness	5	08-30-2003 12:41 AM
Quick questions on Explorer Intake install.	Falcons Talon	Windsor Power	2	08-21-2003 12:40 PM
Several questions about oil.	zepherman	Windsor Power	3	08-03-2002 06:59 AM
HELP! Newbie 95-96 GT questions	Ron Brooks	Blue Oval Lounge	7	07-11-2001 07:38 PM
S/R Questions	DAMION	Racer's Club House	1	09-30-1999 11:02 AM

03-28-2001, 08:29 AM	#2
dinomite The Dude Join Date: Feb 2001 Location: Arlington, VA Posts: 1,262	Ok, I'll work backwards cause you later q's are easier. (H)Uhh, not looking at my car, but other than the connector that goes to the mass air sensor, it needs nothing. (G)I'm pretty sure that its the same 8.8, and aught to work. (E)In place of the stock, anything is. If your looking at new headers check out some long tubes, you need a new H but I've heard its worth it (F)No idea, probably not, but as I said above, you could go w/ longtubes which require a new H. You could get the longtubes, an H with high flows and be set! (3)Check your throttle position sensor (TPS), http://www.mustangperformancetech.ho...TPStuning.html (2)Bent cross memeber eh? I dunno about this, but your best bet is probably to go grab one from a junk yard and replace yours. (B)On the gears, get those installed by a good mechanic, it requires special tools, you can get the speedo gear from many mustang shops (texasmustang.com, mustangsunlimited.com) (A)The stock axels are 28spline, I don't know what else you have to replace if you change them (diff?) but you may want to make a trip to the junk yard again.....You didn't ask about the front rotor/spindle I guess you have that under control?