Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-04-2002, 02:13 PM
|
#7 |
|
Registered Member
Join Date: Mar 1999
Location: Arcadia, CA, USA
Posts: 731
|
You don't have to spend the money for calipers unles you want to. Instead, you can spend $5 for a "machinists scale" which is basically a ruler with calibrations in tenths of an inch. If the clearance is tighter than 0.100, then you could buy the caliper to check. Just tryin to help you save some $.
__________________
Russ L '91 LX - 331 w/ Procharger '03 Cobra Convertible - Pullied '94 Lightning '65 Mustang Coupe |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What head gaskets and intake gaskets?? | dragstang86 | Windsor Power | 4 | 12-20-2002 04:20 AM |
| Re-using head gaskets? | Thad | Windsor Power | 11 | 08-07-2002 10:49 AM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Felpro Head Gaskets | bcinyuz | Windsor Power | 2 | 01-15-2001 01:03 AM |
| Head Gaskets, Header Gaskets, Intake Gaskets, etc | AxemanZZ | Windsor Power | 8 | 01-11-2001 01:09 PM |