MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Distributor gear.... is it steel?
Register FAQ Members List Calendar Mark Forums Read

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 01-08-2002, 07:31 PM   #1
LOWKEY
Registered Member
 
Join Date: Jan 2000
Location: greenvile, NC
Posts: 161
Default
I'm a little lost too. If you have a 5.0 HO motor, (86-95 mustangs did), then it came stock with a roller cam. You shouldn't need to change the distributor gear unless you are installing a flat tappet cam. If you are just swapping to a hotter roller cam you don't need to change the distributor gear.
__________________
89' Notch

Stroked
Poked &
BLOWN

low 11's and it goes around corners too

Parts for Sale!!
http://www.lowkey.stangnet.com/catalog.html
LOWKEY is offline   Reply With Quote
Reply

« Previous Thread | Next Thread »

Thread Tools
Display Modes Rate This Thread
Hybrid Mode Hybrid Mode
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Dist. gear......cast or steel? dwatson Windsor Power 6 04-11-2004 11:32 PM
Stock steel bearing retainer? Merlin76 Windsor Power 1 04-13-2003 08:42 AM
Steel Bearing Retainer! Cannon Windsor Power 6 05-22-2001 07:16 PM
crankshafts: BILLET vs FORGED steel? reddragon93 Windsor Power 1 02-23-2001 12:43 AM
69' Steel 302 Crank - Infor anybody? Shawn Classic Mustangs 2 08-14-2000 11:09 PM


All times are GMT -5. The time now is 11:24 AM.

Archive - Top

SEARCH