Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2001, 01:12 AM
|
#1 |
|
Registered Member
Join Date: Dec 2000
Location: slidell, La
Posts: 73
|
Transmission Install Part II
Well I put my transmission in gear and it seems I got the tailshaft through the clutch plate, but I don't think it went into the flywheel. I guess my only option is to take the bellhousing off and align the clutch again. It seems the cheap alignment tool I bought at the auto parts store sucks!! What do yall think??????
|
|
|
|
03-31-2001, 07:26 AM
|
#2 |
|
Guest
Posts: n/a
|
Just have a helper wiggle the clutch fork with a large prydriver and you should be able to get it to align itself and slide into place. You shouldn't need to pull the bellhousing again. At most, just pull the tranny down and realign things while a helper fiddles with the clutch fork.
------------------ Jeff Chambers T/S #3 11.86 Seconds/113.8 MPH Chambers Racing Team |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speedometer Cable to Transmission O-ring | Kisner | Classic Mustangs | 3 | 07-06-2004 02:13 PM |
| Part install cost | mak375 | Windsor Power | 6 | 12-28-2003 11:18 AM |
| Transmission install problem | 86StangGT | Windsor Power | 4 | 03-30-2001 06:18 PM |
| Hard to locate part for 83 stang help!!! | 83stanger | Small Ponies | 0 | 03-02-1999 08:52 AM |