Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-10-2002, 02:28 PM
|
#5 |
|
Registered Member
Join Date: Dec 1998
Location: Richmond, Virginia
Posts: 449
|
the 83 should have the same size valves as any later 5.0...
I just took the heads off of my 82, and the valves are the same as those in an E7TE. It's just that the ports were terrible on the early 80's heads - that and 67.5cc combustion chambers. If you think that the air bump in an E7TE's exhaust port is restrictive, look at these pre-87 heads.
__________________
1982 Mustang GT |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| to carb, or not to carb...this is my question. | black86notch | Windsor Power | 4 | 08-06-2002 08:24 PM |
| Carb Woahs | RoadWarrior | Classic Mustangs | 4 | 07-27-2002 11:06 AM |
| '65 Carb Question | Wendell Allen | Classic Mustangs | 3 | 07-13-2002 04:54 AM |
| efi to carb. /? | WADS56 | Windsor Power | 0 | 09-26-2001 12:45 AM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |