Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-14-2002, 11:59 PM
|
#3 |
|
Registered Member
Join Date: Nov 1998
Location: southern Illinois
Posts: 312
|
i know when i put mine on my et went down and my trap was a lil faster but my motor was purrty much stock. you will need something to either connect or plug the coolent lines that goes to the spacer , cobra dont use it. i pluged mine with a 2 big screws but a buddy of mine went as far as fabing up a metal line that looked stock. some of that rtv silicone, a fuel line tool to dissconect the lines and be darn carefull with the injectors. might as well change the pvc valve. i went to the ford dealer and bought a new screen and gromet to boot.
__________________
88 gt convertable =-= cobra intake, accufab 65 mm tb headers alum underdrives steeda alum.lca's, springs, c/c plates kyb struts 230 hp to da wheels http://www.cybersteed.freeservers.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cobra tb to intake studs | scale | Windsor Power | 1 | 04-18-2003 11:03 AM |
| cobra intake | scale | Windsor Power | 1 | 04-07-2003 11:36 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| sn95 Cobra intake vs older sn93 Cobra intake | Fordman50 | Windsor Power | 2 | 03-17-2001 01:09 AM |