Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-15-2002, 06:32 AM
|
#3 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
I had a lot of stuff powder coated on my car by powdertech for $80. I had the intake, water neck, and 3 brackets done in gloss black.
If you have it done make sure you clean the inside of the intake really good becauce the sand blast the whole intake and you will have really fine sand inside the intake and I have a friend who did not know that and ruined his motor. They got it all out of mine but did not his.
__________________
James Cox RHC Member #44 nochevy@hotmail.com 1991 Mustang LX Dart iron eagle block, 4340 28oz 347 crank, 4340 h-beam rods, probe ultra light pistons canfield heads “race ported by Brent Frazier”, solid roller cam and lifters “custom grind”, kooks 1 7/8" race headers, and much more. Engine built by Brent Frazier. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| gas prices | mustang145 | Built Ford Tough | 5 | 04-02-2001 05:38 PM |
| gas prices | mustang145 | Modular Madness | 2 | 03-09-2001 05:23 PM |
| gas prices | mustang145 | Blue Oval Lounge | 10 | 03-09-2001 04:20 PM |
| gas prices | mustang145 | Windsor Power | 4 | 03-09-2001 02:02 AM |
| gas prices | mustang145 | Small Ponies | 0 | 03-08-2001 11:32 PM |