Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-15-2002, 09:49 AM
|
#6 |
|
Registered Member
Join Date: Jul 2001
Location: West Bloomfield, MI
Posts: 391
|
the gasket you will be getting with it is too big for the intake ports on the stock heads. if the intake is ported to that gasket you will have a big lip when the intake port meets the head. this will cause a lot of turbulance.
its a simple project, but i wouldnt even bother wasting your time on it now. you will not see any gains. i didnt! once you get some heads, then put it on. i just wished i had waited for my GT-40's before i put it on my stock heads. hope i helped, adam
__________________
90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cobra tb to intake studs | scale | Windsor Power | 1 | 04-18-2003 11:03 AM |
| cobra intake | scale | Windsor Power | 1 | 04-07-2003 11:36 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| sn95 Cobra intake vs older sn93 Cobra intake | Fordman50 | Windsor Power | 2 | 03-17-2001 01:09 AM |