Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-17-2002, 03:05 AM
|
#4 |
|
gear banger
Join Date: Aug 2000
Location: CHICAGO
Posts: 1,144
|
I just have a cheap set of stamped aluminum valve covers that I ordered from modern mustang.
I went to the Victor because I shift at 6600 rpm, plus I can remove the valve covers with the upper on. It was a good move for me because my car is a 80% track car and 347's make enough power down low without a long runner intake anyway. What valve cover gaskets are you using? I am using Earls pressure master gaskets and they are 1/8" thick. If I used some normal gaskets the upper might of fit.
__________________
79 Hatch: NA 347, Stage 2 Canfield Heads, Victor JR. Intake, Blueprinted Holley 750 HP, Solid Roller Cam, Shooting for 10's on motor 93 LX: Tremec, dual friction clutch, fms flywheel, Hedman shorties, O/R H-pipe Ricer hater's club member #49 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| will 86 valve covers fit 94 style mustang | jruppert | Windsor Power | 4 | 05-25-2003 05:16 PM |
| fms valve covers | BLOCKER | Windsor Power | 0 | 05-07-2003 08:34 PM |
| Painted valve covers | surfbeast | Modular Madness | 3 | 04-23-2003 08:19 PM |
| 3.8L ticking under the Valve Covers? | nostang forme | Small Ponies | 2 | 01-02-2003 05:08 AM |
| Valve Covers | Rosco | Windsor Power | 4 | 04-27-2002 08:41 AM |