Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
01-17-2002, 08:26 PM
|
#1 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
My old SD car (88gt) ran 12.4@105 in the 1/4 with the stock ported intake mild ported heads (exhaust side only), chip, 3.55 gears, dynomax 2 1/4" mufflers, gutted cats, k&n, electric fan, and under drive crank pulley. It also had over 140000 miles on it.
It pulled a 2.0 60 ft on 225/60/15's BFG street tires.
__________________
James Cox RHC Member #44 nochevy@hotmail.com 1991 Mustang LX Dart iron eagle block, 4340 28oz 347 crank, 4340 h-beam rods, probe ultra light pistons canfield heads “race ported by Brent Frazier”, solid roller cam and lifters “custom grind”, kooks 1 7/8" race headers, and much more. Engine built by Brent Frazier. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| EFI conversion with Speed Density and a 351w? | PSI GUY | Windsor Power | 2 | 12-02-2001 11:13 PM |
| Speed density conversion | mustangLX92 | Windsor Power | 12 | 06-28-2001 01:49 PM |
| MAF or Speed Density | mustangLX92 | Windsor Power | 2 | 06-26-2001 03:54 PM |
| speed density question.. | bobtodd | Blue Oval Lounge | 2 | 04-15-2001 02:03 AM |