Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-18-2002, 10:22 AM
|
#2 |
|
Registered Member
Join Date: Jan 2002
Location: Dallas
Posts: 24
|
I've got those exact cams in my setup and they make pretty good power. Driveability is sacrificed a little, but nothing that isn't overcomeable. If you can get them that cheap go gor it, my regrinds were $475 for the pair. Below is a dyno with those cams, ported FRPP heads, FRPP intake, and cat-less exhaust:
__________________
Lazer Red '98 GT with flows, 3.73's, clear corners, bumper inserts, billet interior, K&N, 17x8 Steeda Ultralites wrapped in Nitto 555's and DR's, Eibach Sportlines, painted calipers, steeda triax , MGW shift knob, 9mm Taylor plug wires, 90mm Lightning mass-air meter, ported FRPP heads, Crane cam regrinds, FRPP intake, FRPP aluminum driveshaft Mac longtubes/off-road H, .20-over bottom end, Vortech S-trim, MSD Dis4 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MSD or CRANE | Scrapla | Windsor Power | 6 | 05-23-2004 07:31 PM |
| need info on camless engines (electrohydraulic valves) | fiveohpatrol | Blue Oval Lounge | 7 | 01-10-2003 12:41 PM |
| crane 2031 and install | whiterod | Windsor Power | 2 | 04-09-2002 11:24 AM |
| Anyone with some Info?? | BoveK | Windsor Power | 2 | 06-04-2001 01:59 PM |
| crane interceptor 2 | ace1128 | Windsor Power | 1 | 05-30-2001 09:36 PM |