Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-23-2002, 01:44 PM
|
#3 |
|
Registered Member
Join Date: Jan 2001
Location: Kansas
Posts: 59
|
I got my cam in by removing the radiator, and then unbolting the brackets for the a/c condensor......if you have one, and pulling it up out of the way. Good luck
__________________
vortech s trim,edelbrock 6032's, b303, cobra intake, 70mm tb, pro m 75mm bullet, granatelli alum. rad., accel 330+ digital ign., msd boost tim. ret., 30# inj., 190 lph fuel pump, t-rex pump, bbk, press. reg., tremec tko, ram billet flywheel, dual friction clutch, pro 5.0 shifter, 4.10 gears, aluminum quadrant, motorsport alum. driveshaft, hooker headers, off road h pipe, flowmaster cat back, subframes, megabyte jr lowers, heavy duty uppers, eibach springs drag springs, koni sport shocks, polished cobra r's, 85-86 taillights, msd pro billet distributor |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Engine transplant across decades and models. | Sketch | Classic Mustangs | 6 | 04-18-2004 07:51 AM |
| new engine | Torinalth | Modular Madness | 4 | 07-15-2002 09:45 AM |
| Will the 5.0 become obsolete | vetteeatr | Blue Oval Lounge | 36 | 07-11-2002 08:39 PM |
| engine swap | Snakebite427 | Small Ponies | 2 | 10-19-2001 08:17 AM |