Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-25-2002, 07:56 PM
|
#13 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
I wasn't aware 50psi would blow anything up. If it's hangin out at 50psi, and it's not exceeding any safety factors, or anywhere near safety factors for that matter.
His oil pressure certainly shouldn't be less than 30psi at idle, it should be around 40psi with the system functioning properly. I'm not aware of a variable rate bypass on the oil pump, so 50psi just indicates pressure being a little high, not anywhere near blowing stuff up. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much money to build a high 10 sec Honda (using V-tec engine)? | Fox Body | Windsor Power | 27 | 12-11-2002 08:22 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Pushrod Vs. Modular | chetwindell | Windsor Power | 14 | 06-30-2002 05:56 PM |
| 4.6 vs 5.0 | CactusHugger11 | Modular Madness | 11 | 05-01-2002 01:32 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |