 
                    
                  
                    © Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
                    
                  
                MustangWorks.com is designed and hosted by Aero3 Media.
|  | 
|  01-27-2002, 06:36 PM | #1 | 
| Registered Member Join Date: Aug 2000 Location: Wisconsin 
					Posts: 879
				 |   i have the same guages ..i have the whole set up as you can see..mine did make a noise at one time..i started my car and it made a slight pop and would kinda hiss gurgle...found out that there was a kink in the line and the presure poped it and i had a puddle of oil in the back of my vent and it ran down onto the carpet on the floor....not to bad...but id check your line good ..NO KINKS  
				__________________ '91 GT,410W,10.5 to 1 comp,Victor Jr. heads,Victor 5.8 intake,FTI cam,Crane retro fit lifters,Scorpian 1.6 RR's,Melling HV oil pump,MSD distro.,Canton oil pan,FMS flywheel,Romac balancer,FMS timing chain,Accufab 90mm TB,C&L 76mm maf, 42lbers,HD clutch,K&N air filter,Mac long tubes,Pro dumps,powerchamber,FMS 9mm wires,180 thermostat,Ford Racing gauges,5inch Tach,centerline convo pro's,nitto DR's,Pro3i lower control arms,50/50 shocks,3.55 gears,TFS HD diff. cover Next year: Tremec TKO,Spec stage 3 clutch,alum driveshaft,complete fuel system www.angelfire.com/linux/demondan | 
|   |   | 
|  | 
| Thread Tools | |
| Display Modes | Rate This Thread | 
| 
 | 
 | 
|  Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post | 
| installing autometer oil press and water temp | Ieatcamaros | Windsor Power | 5 | 05-06-2003 08:45 PM | 
| Motor back together - strange noise???? | DZEE'S LX | Windsor Power | 13 | 03-15-2002 12:46 AM | 
| Air Intake Whistling Noise?! | sgrn | Modular Madness | 4 | 10-25-2000 09:46 AM | 
 
                    
                  