Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-27-2002, 06:45 PM
|
#3 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
Personally, I'd recommend picking up a manual on it. Set you back about $10 and it will probably come in handy in the future.
Disconnect battery Remove H pipe Remove driveshaft (either insert a stub shaft or drain the tranny) Remove starter Seperate the engine from the tranny Remove radiator shroud Remove fan Remove radiator Disconnect A/C pump from bracket, swing it and the lines out of the way Label and begin disconnecting vacuum lines and electrical connectors. Disconnect throttle linkage Disconnect the heater hoses from the firewall Remove motor mount bolts Hoist the engine out I'm sure I've left out a lot, but those are some things you need to do. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|