Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-29-2002, 03:45 PM
|
#4 |
|
Backyard Mechanic/Chemist
Join Date: Feb 2001
Location: Acton MA USA
Posts: 435
|
Warning!
Whatever you do, only use a Ford Motorcraft PCV valve. The aftermarket ones do not fit tight enough in the grommet and TONS of oil will dump out. It's in a real stupid area as it vents into the lifter galley which has alot more oil spraying around than on the valve covers. But ya gotta live with it. Also when I replaced the PCV I got a new grommet, but that was not as tight to the manifold as the old one was. I ended up putting some black silicone on it to seal better, ( on the side that seals to the intake, not the valve, also dont get any into the screeen below.) now nice and dry ! Some also replace the lower screen as well.
This is much more of a project than it should be
__________________
2001 Crown Vic Maurader Airbox/MAF, DR chip Edel IAS shocks Single exhaust :wtf: 93 P-71 Vic interceptor Backup car now 90 5.0 LX Notch SOLD 74 Chevy Laguna type S-3 454 under construction Currently apart undergoing bodywork. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
| Valve tap!! | SmokinStangGT | Windsor Power | 1 | 07-31-2003 03:42 AM |
| valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
| Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
| PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |