Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-04-2002, 10:55 AM
|
#5 |
|
Registered Member
Join Date: Nov 2001
Location: Scappoose, OR
Posts: 42
|
I found the ceramic coated reference. It was in the Official Ford 5.0 etc., etc. book.
I did clean the whole thing and that's when it started sticking, immediately. I checked the butterfly yesterday and it was tight and the body was clean. I ran it in the driveway for an hour, the engine got good and hot and the TB never stuck. Of course. Guess I'll just have to move up that throttle body purchase. Thanks.
__________________
91 GT - White, MAC cold air induction (that's it so far) 69 GT - Winter Blue, 351, C-4, mild mods 69 Mach I - Acapulco Blue, 351, T-10, bone stock |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help - accelerator pedal replacement | Orange97GTVert | Appearance & Detailing | 0 | 10-05-2004 05:52 PM |
| Clutch pedal to high? | Scrapla | Windsor Power | 5 | 08-15-2004 12:16 PM |
| 4cyl clutch pedal vs 5.0 pedal? | WADS56 | Windsor Power | 5 | 02-05-2002 02:27 AM |
| Clutch pedal and steering questions... | richd | Windsor Power | 2 | 12-19-2001 10:59 AM |
| Need AOD Pedal Assembly.....FAST | Jeff Chambers | Windsor Power | 1 | 11-19-2001 03:02 PM |