Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-05-2002, 10:25 PM
|
#14 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
gtsr515 why do you say to be careful with 1.7's and the B cam? Idle problems or what?
Lift with 1.7's and the B cam comes out to be only .510" which is fine on even a stock HO motor. So theres no reason to be concerned about too much lift, if thats what you are suggesting. I even know some guys that have used 1.7's with the E cam on the stock pistons. Lift there was .529", they probably cut it real close but it still worked fine.
__________________
NMRA O/C 9516 NA pumpgas stickshift 347 10.65@125.6, 6.73@100, 1.41 60ft |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which one C&L 73mm or 76mm? | TwiLighTBluEGT | Windsor Power | 5 | 01-13-2003 04:35 PM |
| Help with C&L 76MM & A9L computer install | venumus93 | Windsor Power | 19 | 05-16-2002 07:58 PM |
| CAI with C&L inlet tube? | chris91LX | Windsor Power | 11 | 04-16-2002 08:20 PM |
| which MAF? 73mm, 76mm, 80mm?? | acidangel316 | Windsor Power | 8 | 06-19-2001 02:37 PM |
| 73mm C&L | gray87GT | Windsor Power | 3 | 03-15-2001 01:06 PM |