Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-11-2002, 01:30 PM
|
#3 |
|
Registered Member
Join Date: Sep 2001
Location: zachary, la
Posts: 73
|
it took me a good day and a half, this included very hard cleaning of the block and a few other details to make sure it went off without a hitch. i'm sure if i had to do it again it would go alot quicker, it was my first time
__________________
GT-40X(58cc)heads, cobra upper&lower, FMS 65mm TB, 75mm Bullet, 24# injectors, 190 lph fuel pump, moroso cold air intake, BBK 1 5/8 equal length headers, flowmaster cat back, 1.7 cobra rockers, crane 2031, T5Z gear box, centerforce dual friction, mcleod bullet proof bellhousing, 3.55 gears, hurst billet shifter with over 193,000 miles. thanks to all who contributed |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Heads. Any Tips | 66StangGuy | Classic Mustangs | 5 | 09-15-2003 08:20 PM |
| Edel. non-smog to AFR smog legal heads? What do you guys think? | Simi Stang | Windsor Power | 10 | 06-19-2003 11:14 PM |
| My NEW replacement Holley heads are different! | Rick 91GT | Windsor Power | 8 | 04-23-2001 06:45 AM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |