Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-09-2001, 06:23 AM
|
#5 |
|
Moderator
Join Date: Aug 2000
Location: Milan, OH
Posts: 2,699
|
Yeah, the B&M remote filter kit is only $25. Plumb it in between the tranny and the cooler (I put mine on the right side frame rail by where the charcoal cannister goes). That way if the tranny breaks, the contaminants are filtered out before they get to the pump in the converter. The filter is also a great way to extend the life of the tranny to begin with. The regular filter in the pan only catches the big stuff, the remote filter unit catches stuff down to 10 microns...and it uses a standard FL-1A filter to boot.
My cowl is 2.5 inches. Its the Cervini's Stormin' Norman hood. ------------------ Jeff Chambers Trophy Stock #3 11.86 Seconds / 113.8 MPH Chambers Racing Team |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Torque Converter Install and Question | Red5Ltr | Windsor Power | 41 | 07-09-2004 01:50 PM |
| Another "which stall speed conv" thread! | crazypete | Windsor Power | 8 | 10-10-2003 02:45 AM |
| Torque Converter Lockup Q | Nixon1 | Windsor Power | 3 | 02-14-2003 03:00 PM |
| Whats the best Torque Converter | Brady91 GT | Windsor Power | 6 | 06-21-2001 12:42 AM |
| code 628 - Excessive converter slippage??? | slo95 | Windsor Power | 7 | 05-05-2001 01:18 PM |